Skip to content

Clean, −16 LUFS, −1 dBTP, export: one pass

Podcast Enhancer: Clean to −16 LUFS

AudioCleaner is a podcast enhancer for one episode: it removes noise or echo, sets −16 LUFS (−14 for YouTube), holds peaks under −1 dBTP and exports WAV, MP3 or your MP4, up to 30 minutes. AI cleanup uses credits; a steady hum is cleaned free in your browser.

How it works
  • Clean, Then −16 LUFS
  • Peaks Held Under −1 dBTP
  • Measured Before You Download
  • Video Podcasts Keep the Picture
  • Try the First Minute

A podcast intro recorded in a café

Café chatter · Podcast · Studio voice

Made noisy on purpose and cleaned on our partner studio, as it came out. The page lines the tracks up so you can switch while it plays.

0:00 / 0:00

Studio voice: the voice rebuilt without the room, so echo and other voices are gone too.

Room sound kept0%

Brings a little of the original room back under the rebuilt voice.

Playback here is matched to it, so the comparison is fair.

What your download will measure

Cleaned with
Studio voice
Loudness
Measuring…
True peak
Measuring…
Export
WAV (48 kHz, 16-bit) or MP3 (192 kbps), mono

Your files and results are visible only to you; runs are kept 7 days.

Up to 30 min · 400 MB

MP4 · MOV keep the picture

One file at a time · no speaker levelling, filler-word cuts or multitrack mixing

clean, loudness, peak, export
4 steps
podcast apps, or −14 for YouTube
−16 LUFS
true-peak ceiling on the download
−1 dBTP
loudness and peak shown on the result
Measured
video episodes back with the picture
MP4 · MOV
per episode file, up to 400 MB
30 min

What the Podcast Enhancer Does in One Pass

Four steps in a fixed order, measured before you download.

How to Use the Podcast Enhancer in 3 Steps

The podcast enhancer’s free mode needs no account; Clean and Studio voice need a sign-in and show their price first.

  1. 01

    Open the episode

    One file up to 30 minutes and 400 MB: WAV, MP3, M4A, FLAC, MP4 or MOV. It is read in your browser; nothing goes up before an AI run.

  2. 02

    Pick the need and the target

    Choose what the episode needs and where it goes: podcast apps at −16 LUFS or YouTube at −14. Try the first minute and compare.

  3. 03

    Run it and download

    Run the whole file, check the measured numbers, then download WAV (48 kHz, 16-bit), MP3 (192 kbps) or the video.

Podcast Voice Enhancer Examples, Before and After

Three recordings through the podcast enhancer: a café intro, a stairwell interview, a lecture under the air conditioning.

A podcast intro recorded in a café

Studio voice keeps the host and drops the tables around; Cleaned is the gentler mode, every voice kept.

Our sample: made noisy on purpose and cleaned on our partner studio, as it came out.

Original
100%
More naturalMore removal
Mixes the original back in, live in your browser; nothing is processed again. The [ and ] keys change it.
Chatter in the pauses
−23 dB−72 dB
Download, Studio voice
−16.0 LUFS · −1.4 dBTP

In the café, Studio voice takes the chatter between phrases from about −23 dB to −72 dB. The lecture’s hum, cleaned free, falls from −22 dB to −36 dB; the file then reads −17.5 LUFS, and the download lands at −16.0 LUFS, true peak −1.7 dBTP.

Who Uses a Podcast Audio Enhancer

Weekly shows, recorded wherever there was a free room.

A smiling man recording at home with a guitar on the wall

Solo Shows Recorded at Home

A desk, a laptop fan, a bare wall: the noise goes and the episode lands at −16 LUFS.

Two people talking over coffee at a window table

Interviews and Remote Guests

A guest on a laptop mic sounds thin and roomy: Studio voice rebuilds the voice.

A man at a window looking out over a harbour at night

Video Podcasts for YouTube

A filmed episode in, the same MP4 out at −14 LUFS, the picture untouched.

Why clean first, then set the loudness

Noise counts toward loudness: level a noisy file and the voice ends up quieter once the noise is gone. So the podcast enhancer always cleans, then applies one overall gain, then limits the few peaks that would cross −1 dBTP. No compressor: your dynamics stay as recorded.

What your podcast editor still does

This pass works on a finished mix or on one speaker’s track. Keep these for podcast editing:

  1. 1Cutting mistakes, filler words and long pauses.
  2. 2Balancing a quiet guest against a loud host, with a compressor or by hand.
  3. 3Music, intros and mixing several tracks into one.

Each person on their own track? Clean each file here, mix them in your editor, then set the mix to −16 LUFS with normalize audio, free.

Before you publish

A last check takes a minute:

  1. 1Listen to the first minute and to the loudest laugh.
  2. 2Read the report: about −16 LUFS, true peak at or under −1 dBTP.
  3. 3Uploading to Apple Podcasts Connect? It accepts mono MP3 but not mono WAV: choose MP3.

Want the numbers explained? Read what LUFS should a podcast be.

A Podcast Enhancer That Keeps Episodes Private

Only the sound goes up

An AI run sends the sound only, never a video’s picture; the free mode sends nothing.

Unreleased stays unreleased

Podcast enhancer results are yours alone, kept 7 days, and a run can be deleted at any time.

Pay only for what you keep

The price shows first, one minute can be tried alone, and a failed run refunds.

Podcast Enhancer FAQ

What it does, what it leaves to your editor, loudness, video, price.

Run This Week’s Episode Through the Podcast Enhancer

Open the episode, pick what it needs and download it clean at −16 LUFS, peaks under −1 dBTP: one podcast enhance pass, the price on the button first.