Skip to content

Declip, declick, de-hum, de-hiss, de-muffle

Free Audio Repair in Your Browser

AudioCleaner repairs damaged recordings in your browser: clipping, clicks and crackle, 50 or 60 Hz hum, hiss and static, muffled audio. This audio repair is free, with no sign-up, no upload and no watermark. It diagnoses the file first and suggests the fixes.

How it works
  • Free, No Sign-up
  • Nothing Uploaded
  • No Watermark
  • Diagnose, Then Fix
  • WAV or MP3

Loading the demo…

The sound is decoded here, in your browser.

Free, no sign-in. Your file never leaves this device.

Up to 30 min · 400 MB

no sign-up, no watermark
Free
repaired on your device
Not uploaded
declip, declick, de-hum, de-hiss, de-muffle
5 fixes
hum found on its own
50 / 60 Hz
Original, Repaired, Removed
3 views
or an MP4 / MOV back, picture kept
WAV or MP3

Audio Repair Tools for Five Kinds of Damage

It listens first, says what it found, and turns on only the fixes the file needs.

How to Use Audio Repair in 3 Steps

No account and no upload: everything runs on your device.

  1. 01

    Drop the recording

    A WAV, MP3, M4A, FLAC or OGG file, or a video, up to 30 minutes. The diagnosis starts on its own.

  2. 02

    Check the suggested fixes

    Keep the fixes it turned on, or switch on one it did not suggest. Set how hard each one works and run.

  3. 03

    Compare and download

    Switch between Original, Repaired and Removed, then download WAV, MP3 or the video.

Audio Repair Example: A Damaged Voice Memo

A clean voice we damaged on purpose with 50 Hz hum and clipped peaks, then ran through the diagnosis and the fixes it suggested.

The diagnosis found 1,285 clipped spots and hum at 50 Hz with six harmonics, and switched on declip and de-hum only. After the run the hum was about 40 dB lower, the flat tops were rebuilt from the waveform around them, and with the level kept the download came out 0.9 dB lower so the new peaks fit.

What People Bring to Audio Repair

Recordings that cannot be made again.

An empty chair under a spotlight on a stage

Old Tapes and Records

Clicks, hiss and hum from a transfer, cleaned without touching the music.

A man speaking quietly by a window at night

Voice Memos Recorded Too Loud

Flat, harsh peaks from a phone held too close, rebuilt where they can be.

An open book and a cup of coffee on a desk

Lectures With a Humming Mic

Mains hum from a long cable under a talk, notched out at its pitch.

Audio Repair That Never Leaves Your Device

Nothing uploaded

The diagnosis and every fix run in the browser tab.

No account, no watermark

Free as often as you like, with nothing added to the file.

Stereo kept

A stereo file stays stereo up to 10 minutes; longer ones are repaired in mono, with a notice.

Dull, boxy recordings

A dull recording is missing its highs: the mic faced away, sat under clothing or behind a laptop, or a call app cut the treble. De-muffle, the last audio repair step, cuts the boxy low mids and lifts presence and air. Highs that were never recorded cannot come back. The page to fix muffled audio opens on this repair alone.

Flat-topped peaks

When a signal is louder than the recorder can store, the top of every peak is cut flat and loud words sound harsh. The declipper, the first audio repair step, treats the flat run as missing and rebuilds it from the waveform around it. Light damage comes back well; heavy damage improves only a little, because too much of the wave is gone. More on clipping audio and how to fix it.

Hum, buzz, hiss and static

Hum is the mains frequency, 50 Hz in most of the world and 60 Hz in the Americas, leaking in through a cable or a ground loop; a buzz is the same hum with many harmonics. De-hum notches those exact pitches, and a whine or a drifting hum is not mains hum. Hiss and static are broadband and steady, so they are turned down where the voice is not. Dedicated pages: static remover and remove buzz from audio.

Noise that changes, such as wind, traffic or a café, is not damage: the background noise remover handles it with AI.

Spectral repair and old tapes

Spectral repair means editing the spectrum: finding a sound by its frequency and taking it out. This tool does that automatically for mains hum and a steady hiss; there is no spectrogram to select or paint a cough out by hand. To restore old tape recordings, turn on declick, de-hum and de-hiss: the fixes always run in the same order, declip, declick, de-hum, de-hiss, de-muffle. A voice that needs rebuilding rather than repairing has an AI mode on the audio enhancer page.

Audio Repair FAQ

Free use, privacy, and what each fix can and cannot do.

Try Audio Repair on Your Recording

Drop a file, let the diagnosis pick the fixes, and download it repaired. Free, and nothing leaves your device.